Automatic cutting machine formal method of operation

Before using the first Automatic cutting machine must be sure the work surface and the cutter is not kept below the level of the state, if not, the first thing to do is to adjust the level, then check the cutter steel cutter There are no abnormal phenomenon, for example, there is no crack crack, screw fastening tool is not, but also turned by hand at the pulley, check the top of the backlash is not appropriate, and if we find inappropriate, first adjust better.
Plug in the power, the start time, do not worry now operating on steel, should first dry run for a while, take a look at every part of the operation is not a normal Automatic cutting machine, to determine a good no anomalies, then you can really start operate. In the cut material time, pay more attention to the correctness of the staff is a hand operation, and posture on. Middle and lower use of Automatic cutting machine should cutter, hand grip bars to the staff, and aligning the entrance of the cutter. If you are a person to operate it, the staff must be fixed position, can only stand on the side of the blade and hard pressed steel, in the course of their work should not arbitrarily change position, to avoid wounding steel.
If the Automatic cutting machine can not be more than a one-time cut rebar, then do not do it abruptly, range of different steel cutting machine has a work must be able to ensure the safety of staff inside the operating range.